Reviews (6)

I was so pleased by this stove, at first I was kind of wondering if I can trust this new company .I changed my mind right after I received this stove . The customer service is very nice, the stove is well made and easy use.

We got the three windowed Woods Night T1 with the side racks it only took six days to arrive. Nothing was damaged in shipping.

The wall panel thickness is thicker than any currently on the market so far, and the reinforced supports on the lid and under the belly of the stove are very impressive. The threaded side racks have a brass insert that will fall out over time so I used a pin punch to dimple the leg when it was fully threaded approximately a half centimetre or 1/16 inch from the top on four sides of each tube, this effectively stopped the brass insert from sliding out of the hollow leg just have to be careful not to crush the threaded collar into the inner threads.

On the chimney pipe I used a long smooth pole eight foot or 244 CM in length - one inch or 25.4 CM diameter to gently curve the flexible roll vertically on a very flat rubber sports floor surface of course using the cut resistant gloves and had work gloves on my helper and had the stainless rings laid out every 30 CM or one foot. Be very careful not to wrinkle or crease the pipe before it is formed in to shape and heat treated, if you take your time it will keep its shape unless you excessively fold it. Once heat treated you can roll it Horizontally as it was originally shipped and next time can be vertically rolled much easier as it has a memory to the shape it was heated.

I used a propane Torch to heat treat all surfaces first take off the rubber caps on the rack legs.

You must also be very careful because this can over heat the metal and warp it you must move and keep moving around very quickly paying close attention to the colours - colour range goes from greyish silver to orange to red to purple to blue then to white silver - never heat any part past blue colour or you can risk burning through, if you are not experienced with this I would say stick with using wood to do your first burn. Otherwise I had next to no warping by doing this method but I also have had many years of welding experience, so if you try and fail don't ask for replacement as this is only my tip to you as a fellow consumer.

Good luck and I can't wait to take this hot tent camping.

Got My T1 Woods Night today, Ordered from Canada. My Stove arrived Very quickly. I put it all together no instructions needed. Went together so fast and easy absolutely love it. 5.0 Stars exactly what i was expecting quality is great.